215676
257
Revision A
1000780
B
A
Figure 4.212: Header Boot
6.
Remove the hairpin from clevis pin (A), and remove the
clevis pin from header boots (B).
7.
Repeat the previous step on the other side of the header.
1000797
A
B
Figure 4.213: Header Stand
8.
Lower stand (A) by pulling clevis pin (B), inverting the stand,
and positioning the stand on the bracket. Reinsert pin (B)
and secure it with a hairpin.
1008711
A
B
Figure 4.214: Header Float Linkage
9.
Check that the float engagement pin is installed in storage
position (B) and
NOT
in the engaged position.
IMPORTANT:
To prevent damage to the lift system when lowering the
header lift linkages without a header or a weight box
attached to the windrower, ensure that the float
engagement pin is installed in storage position (B) and
NOT
in the engaged position.
Remove the lynch pin from the clevis pin, and remove the
clevis pin from engaged position (A) in the linkage to
disengage the float springs.
10. Insert the clevis pin into storage hole (B). Secure it with a
lynch pin.
11. Repeat the previous step on the other side of the header.
