215676
277
Revision A
1008810
A
C
B
D
Figure 4.263: Mechanical Center-Link
6.
Shut down the engine, and remove the key from the
ignition.
7.
Loosen nut (A) and rotate barrel (B) to adjust its length until
the link is aligned with the header bracket.
8.
Install clevis pin (C) and secure it with cotter pin (D).
9.
Adjust the length of the link to achieve the proper header
angle by rotating barrel (B). Tighten nut (A) against the
barrel (a slight tap with a hammer is sufficient).
1008946
A
Figure 4.264: Ground Speed Lever
DANGER
Ensure that all bystanders have cleared the area.
10. Start the engine.
11. Press HEADER UP switch (A) to raise the header to its
maximum height.
12. If one end of the header does
NOT
fully rise, rephase the
lift cylinders as follows:
a.
Press and hold the HEADER UP switch until both
cylinders stop moving.
b.
Continue to hold the switch for 3
–
4 seconds. The
cylinders are now phased.
NOTE:
It may be necessary to repeat this procedure if there is air in the hydraulic system.
