215676
96
Revision A
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 3.86: CDM Programming Buttons
1.
Turn the ignition key to the RUN position, or start the
engine.
2.
Press PROGRAM (A) and SELECT (C) simultaneously on the
CDM to enter programming mode.
•
WINDROWER SETUP? will appear on the upper line.
•
NO/YES will appear on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? will appear on the upper line.
1009090
HEADER INDEX MODE?
CXXX
MXXX
REEL & CONVEYOR
D
C
B
A
Figure 3.87: Header Index Mode
4.
Press SELECT (D) until HEADER INDEX MODE? appears on
the upper line.
•
REEL & CONVEYOR or REEL ONLY will appear on the
lower line.
5.
Press left arrow (B) or right arrow (C) to set HEADER INDEX
mode. Press SELECT (D).
6.
Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to the next WINDROWER SETUP
option.
Setting Return to Cut Mode
Enabling the return to cut feature in the cab display module (CDM) allows the Operator to make use of height and
(optionally) tilt position presets. The return to cut feature can be configured by accessing the RETURN TO CUT MODE sub-
menu in the WINDROWER SETUP menu.
For more information on the Return to Cut feature, refer to
.
NOTE:
The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM) automatically
adjusts its programming for each header. For more information, refer to
4.5 Attaching and Detaching Headers, page 215
.
1.
Turn the ignition key to the RUN position, or start the engine.
