215676
433
Revision A
6.
Start the engine. Operate the windrower for a few minutes, then stop and check the oil level. If necessary, add
more oil.
Changing Wheel Drive Lubricant
The wheel drive lubricant should be changed according to the interval specified in the maintenance schedule. Change the
lubricant when it is warm.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator
’
s seat for any reason.
CAUTION
Park on a flat, level surface with the header on the ground, the ground speed lever (GSL) in the N-DETENT position, and
the steering wheel in the locked position (centered). To confirm that the parking brake is engaged, wait for the cab
display module (CDM) to beep and display the message IN PARK.
1007553
A
B
Figure 5.203: Drive Wheel Hub
1.
Park the windrower on level ground. Position the
windrower so that one of drain plugs (A) or (B) is at the
lowest point on the drive wheel hub, as shown.
2.
Shut down the engine, and remove the key from
the ignition.
3.
Place a container large enough to hold at least 2 liters
(2 quarts) of fluid under lower drain plug (B).
4.
Remove both plugs (A) and (B). Allow the lubricant to drain
completely into the container.
CAUTION
Dispose of oil in a manner that complies with local rules and
regulations.
1007544
A
B
C
Figure 5.204: Drive Wheel Hub
5.
After the lubricant has drained completely, start the
windrower and position it so that the imaginary line
running through (A) and (B) and center hub (C) is parallel
with the ground, as shown.
6.
Shut down the engine, and remove the key from
the ignition.
7.
Add lubricant to the wheel drive. For instructions, refer to
Adding Wheel Drive Lubricant, page 432
.
