215676
134
Revision A
1009335
CXXX
MXXX
FORCE HEADER TYPE?
NO/YES
A
B
Figure 3.174: Header Type
5.
Press SELECT (B) until FORCE HEADER TYPE? appears on the
upper line.
•
NO/YES will appear on the lower line.
6.
Press right arrow (A) to select YES. Press SELECT (B).
•
SELECT HEADER TYPE will appear on the upper line.
•
DISK HEADER will appear on the lower line.
1009336
CXXX
MXXX
SELECT HEADER TYPE
DISK HEADER
A
B
C
Figure 3.175: Header Type
7.
Press left arrow (A) or right arrow (B) to cycle through the
list of header types.
8.
When the desired header type appears, press SELECT (C).
•
EXIT FORCE HEADER? will appear on the upper line.
•
NO/YES will appear on the lower line.
9.
Press right arrow (B) to select YES. Press SELECT (C).
Proceed to the next diagnostic option, or press PROGRAM
to exit programming mode.
3.19.14
Troubleshooting Header Problems
Refer to this section if you are encountering difficulties configuring header features in the cab display module (CDM).
Testing Header Up/Down Activate Function Using Cab Display Module
The cab display module (CDM) can be used to change the height of the attached header, rather than using the height
controls on the ground speed lever (GSL). This procedure is used to test the functionality of this feature.
NOTE:
•
Before performing this procedure, the header must be attached to the windrower. The CDM automatically adjusts its
programming for each header. For more information, refer to
4.5 Attaching and Detaching Headers, page 215
•
The engine must be running to perform this procedure.
DANGER
Ensure that all bystanders have cleared the area.
