215676
93
Revision A
To set the knife overload speed:
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 3.80: CDM Programming Buttons
1.
Turn the ignition key to the RUN position, or start the
engine.
2.
Press PROGRAM (A) and SELECT (C) simultaneously on the
CDM to enter programming mode.
•
WINDROWER SETUP? will appear on the upper line.
•
NO/YES will appear on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? will appear.
1009082
CXXX
MXXX
KNIFE OVERLOAD SPD?
-300 SPM
D
C
B
A
Figure 3.81: Knife Overload Speed
4.
Press SELECT (D) until KNIFE OVERLOAD SPD? appears on
the upper line.
•
The currently configured knife overload speed will
appear on the lower line.
NOTE:
The default knife overload speed setting is -300 strokes per
minute (spm). The possible input range is -500 to -100 spm.
5.
Press left arrow (B) or right arrow (C) to set the knife
overload speed. Press SELECT (D).
6.
Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to the next WINDROWER SETUP
option.
Setting Rotary Disc Overload Speed
The rotary disc overload speed setting determines the reported rotary disc speed at which a disc overload speed warning
will appear on the cab display module (CDM). By default, this is 75% of the configured rotary disc speed, but this setting
can be changed by accessing the DISC OVERLOAD SPD sub-menu in the WINDROWER SETUP menu.
NOTE:
•
The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header. For more information, refer to
.
•
The recommended disc overload speed is 75% of the configured disc speed. For more information, refer to the rotary
disc header operator
’
s manual to determine the appropriate disc overload speed setting.
