215676
77
Revision A
Display (Lower or Upper Line)
Description
ENGINE TEMP ### °F
ENGINE TEMP ### °C (if metric)
Engine coolant temperature
SCROLL
SUB-MENU (lower line only)
#### KNIFE SPEED
##.# AUGER SPEED
##.## REEL RPM
##.# HEADER HEIGHT
Displays sub-menu after 2
–
3 seconds. Press SELECT to cancel. Scroll through
sub-menu display with CDM switch
Knife speed is optional
Reel rpm is optional
Cab-Forward, Engine Running, Header Engaged, Draper Header Attached, Index Switch OFF
These are the messages which can appear in the cab display module (CDM) when the windrower is in cab-forward mode,
the engine is running, the attached draper header is engaged, and the header index switch is set to the OFF state.
Display (Lower or Upper Line)
Description
#####.# ENGINE HRS
Displays the total engine operating time
#####.# UNIT HRS
Displays the windrower
’
s total operating time
#####.# HEADER HRS
Displays the header
’
s total operating time
##.# ACRES/HOUR
##.# HECTARES/HOUR (if metric)
Displays the actual cutting rate in acres or hectares per hour
###.# SUB ACRES
###.# SUB HECTARES (if metric)
Displays the total area cut since the last reset was performed. To reset this
value: set the CDM to display SUB ACRES on the lower line, then hold down
the PROGRAM switch for five to seven seconds until the display resets
###### TOTAL ACRES
###### TOTAL HECT (if metric)
Displays the total area cut by the machine
##.## REEL MPH
##.## REEL KPH (if metric)
##.## REEL SENSOR (flashing)
Displays the reel
’
s peripheral speed in miles per hour or kilometers per
hour.
This message appears if the reel sensor is disabled. The messages MPH /
KPH and SENSOR appear alternately at one-second intervals
##.# DRAPER SPEED
Displays the speed of the draper (0.0
–
11.0)
#### KNIFE SPEED
#### KNIFE SENSOR
Displays the knife speed in strokes per minute
This message appears if the knife speed sensor is disabled. The messages
SPEED and SENSOR appear alternately at one-second intervals
##.# HEADER HEIGHT
##.# HEADER SENSOR
Displays the distance setting (00.0
–
10.0) between the cutterbar and the
ground
This message appears if the header height sensor is disabled. The messages
HEIGHT and SENSOR appear alternately at one-second intervals
##.# HEADER ANGLE
##.# HEADER SENSOR
Displays the angle setting (00.0
–
10.0) of the header relative to the ground
This message appears if the header angle sensor is disabled. The messages
ANGLE and SENSOR appear alternately at one-second intervals
##.# L FLOAT R ##.#
FLOAT SENS DISABLED
Displays the left and right float settings (0.0
–
10.0)
This message appears if the float sensor is disabled
### °C or F HYD OIL TEMP
### °C or F HYD SENSOR
Displays the temperature of the hydraulic oil
This message appears if the temperature sensor is disabled. The messages
TEMP and SENSOR appear alternately at one-second intervals
