215676
190
Revision A
1007630
A
B
Figure 4.66: Wheel Drives
–
10 Bolt
2.
Remove two bolts (A) at the center of the drive wheel.
3.
Remove cap (B) and flip it over so that the convex side
faces in. The cap depresses a pin which disengages the
wheel drive.
4.
Reinstall bolts (A) to secure cap (B).
5.
Repeat Step
to Step
on the other
drive wheel.
6.
To engage the wheel drives:
reverse cap (B). Ensure that
the pin at the center of the wheel pops out to engage the
wheel drive.
NOTE:
Engaging the wheel drives may require rocking the wheels
slightly.
4.3.9
Storing Windrower
Follow these steps at the end of each operating season to properly store the windrower.
WARNING
Never use gasoline, naphtha, or any volatile material for cleaning purposes. These materials are toxic and can be
flammable.
CAUTION
Never operate the engine in an unventilated building. Proper ventilation is required to prevent exhaust gas hazards
from occurring.
CAUTION
All of the exposed metal parts on a battery are electrically conductive. Never lay a metal object across the battery
terminals; this will cause a short-circuit.
1.
Clean the windrower thoroughly.
2.
Store the windrower in a dry, protected place.
3.
Remove and properly store the windrower
’
s batteries. For instructions, refer to
.
4.
Charge the windrower
’
s batteries and store them in a cool, dry area in an upright position. Do
NOT
stack one battery
on top of another unless the batteries are both in cartons.
5.
If the windrower is to be stored outside, cover the windrower with a waterproof tarpaulin or other protective material.
6.
If no cover is available, seal the air cleaner intake and exhaust pipe with plastic bags and/or waterproof tape.
7.
If possible, store the windrower on blocks to take the weight off of the tires. If blocking up the machine is not possible,
increase the tire pressure by 25% over the recommended level. Be sure to adjust the tire pressure to the
recommended operating value before the windrower is operated.
8.
Repaint all worn or chipped painted surfaces to prevent rust.
9.
Lubricate the windrower thoroughly, leaving excess grease on the grease fittings. Apply grease to the exposed threads
and the sliding surfaces of components.
