215676
114
Revision A
1009217
CXXX
MXXX
DRAPER SPEED
ENABLED/LOCKED
D
C
B
A
Figure 3.127: Draper Control Lock
6.
Press SELECT (D) until DRAPER SPEED appears on the
upper line.
•
ENABLED/LOCKED will appear on the lower line.
7.
Press left arrow (B) to enable the DRAPER SPEED control
switch, or press right arrow (C) to lock the DRAPER SPEED
control switch.
8.
Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to the next WINDROWER SETUP
option.
Activating Auger Speed Control Lockout
Activating the auger speed control lockout in the windrower
’
s cab display module (CDM) prevents unauthorized Operators
from changing the auger speed of the attached header.
NOTE:
•
This procedure applies to windrowers with attached A40D Auger Headers only.
•
An auger header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header. For more information, refer to
.
To activate the auger speed control lockout:
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 3.128: CDM Programming Buttons
1.
Turn the ignition key to the RUN position, or start the
engine.
2.
Press PROGRAM (A) and SELECT (C) on the CDM to enter
programming mode.
•
WINDROWER SETUP? will appear on the upper line.
•
NO/YES will appear on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? will appear on the upper line.
