215676
223
Revision A
1000767
A
B
Figure 4.125: Header Leg and Boot
5.
Drive the windrower slowly forward until boots (A) enter
header legs (B). Continue driving slowly forward until the
lift linkages contact the support plates in the header legs
and the header is nudged forward.
6.
Ensure that the lift linkages are properly engaged in the
header legs and are contacting the support plates.
1022527
A
B
Figure 4.126: Ground Speed Lever
7.
Use the following GSL functions to position the center-link
hook above the header attachment pin:
•
HEADER TILT UP (A) to retract the center-link
•
HEADER TILT DOWN (B) to extend the center-link
8.
Shut down the engine, and remove the key from
the ignition.
1029715
A
B
Figure 4.127: Hydraulic Center-Link
9.
Push down on the rod end of link cylinder (A) until hook (B)
engages and locks onto the header pin.
IMPORTANT:
The hook release must be down to enable the self-locking
mechanism. If the release is open (up), manually push it
down after the hook engages the header pin.
10. Check that center-link (A) is locked onto the header by
pulling upward on the rod end of the cylinder.
