215676
196
Revision A
Adjusting Float Using Drawbolts
Coarse float adjustment is done using the drawbolts located on both sides of the windrower.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator
’
s seat for any reason.
DANGER
Ensure that all bystanders have cleared the area.
1008946
A
Figure 4.71: GSL
1.
Start the engine.
2.
Using HEADER UP switch (A) on the ground speed
lever (GSL), raise the header fully.
3.
Shut down the engine, and remove the key from the
ignition.
1013762
A
Figure 4.72: Header Float Adjustment
4.
Turn drawbolt (A) clockwise to increase the float, or
counterclockwise to decrease the float.
5.
Check the header float again. Refer to
for instructions.
Float Options
The float system can be programmed for three types of windrowing conditions when using an attached draper header
(without the deck shift option), an auger header, or a rotary disc header.
The Operator may wish to have three different float settings available to them for different harvest conditions. For
example:
•
Position 1: Border conditions
•
Position 2: Normal conditions
•
Position 3: Rocky conditions
