215676
209
Revision A
4.
Press right arrow (D), then SELECT. SET KNIFE SPEED? will appear.
5.
Press SELECT (C) until AUTO RAISE HEIGHT appears.
6.
Press left arrow (E) or right arrow (D) to change the auto raise height value on the lower line. The acceptable auto
raise height values range between 4.0 to 9.5. At 10.0, the feature is disabled and OFF will be displayed.
7.
Press PROGRAM (B) to exit programming mode.
Using Auto Raise Height Feature
The header can be raised to a preset height by enabling the auto raise height feature in the cab display module (CDM).
Once this feature has been configured, the header can be raised to the preset height by rapidly double-pressing the
HEADER UP switch.
IMPORTANT:
To use the auto raise height feature, the windrower
’
s engine must be running, the header must be engaged and sitting at
the preset cutting height, and the return to cut feature must be active.
1009780
A
B
C
Figure 4.95: Operator
’
s Station
1.
To raise the header to the auto raise height set-point,
double-press (press the button twice within 0.5 seconds)
HEADER UP switch (B) on the ground speed lever (GSL).
NOTE:
When the AUTO RAISE HEIGHT switch is set to ON, the
ACRE counter will be disabled when the header is raised
higher than the preset cutting height.
2.
If desired, press the HEADER UP switch while the header is
being raised to disable auto raise height. The header will
maintain its current height.
NOTE:
When the AUTO RAISE HEIGHT switch is set to OFF, the
ACRE counter will be disabled when the header height
value is greater than 9.5. OFF will be displayed on the cab
display module (CDM).
3.
To return the header to the preset cutting height,
momentarily press HEADER DOWN switch (C).
4.4.9
Header Drop Rate
The header should fall gradually when the HEADER DOWN switch is pressed. The header should be able to drop from the
fully raised to the fully lowered position in 3
–
4 seconds.
If the drop rate requires adjustment, refer to
