215676
409
Revision A
1000892
B
A
Figure 5.165: Red Taillights
1.
Shut down the engine and remove the key from the
ignition.
2.
Turn the lights OFF.
3.
In the grille of the hood, remove two screws (A) from
light (B). Remove the light.
4.
Remove the connector from the light.
5.
Connect the wiring harness to new light (B). Install the light
and secure it with screws (A).
5.10.10
Replacing Beacon Lights
If a beacon is damaged or defective, the entire unit will need to be replaced.
1019726
A
B
C
D
E
F
G
Figure 5.166: Replacing Beacons
1.
Disconnect wiring (A) from harness.
2.
Remove nuts (B) and remove beacon (C) from support (D).
Discard the beacon and the its attachment hardware.
3.
Clean the residue from support (D).
4.
Install new beacon (C) with gasket (E) onto the support.
Secure the beacon with bolts (F), washers (G), and nuts (B).
5.
Torque the nuts to 0.65 Nm (5.75 lbf·in).
IMPORTANT:
Do
NOT
exceed a torque value of 2.0 Nm (17.7 lbf·in).
6.
Connect wiring (A).
7.
Ensure that the beacons operate correctly. For instructions,
refer to
3.7 Exterior Lighting, page 47
.
5.10.11
Replacing Console Gauge Light
If a console gauge light is burned out or damaged, it will need to be replaced.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator
’
s seat for any reason.
1.
Shut down the engine, and remove the key from the ignition.
2.
Turn the lights OFF.
