215676
78
Revision A
Display (Lower or Upper Line)
Description
LOAD|
■■■■
| | ####
This bar graph represents the hydraulic operating pressure of the circuit in
which the hydraulic pressure sensor is installed. The bars will appear to be
full if the preprogrammed overload pressure (17,237
–
34,474 kPa
[2500
–
5000 psi]) is reached. If the hydraulic pressure sensor is disabled, this
message will not appear
11
##.# VOLTS
Displays the engine electrical system
’
s operating voltage
##.# SWATH COMPR HT
SWATH CO SENSOR
Displays the swath compressor
’
s height setting(00.0
–
10.0); fully raised is 0
This message appears if the swath compressor height sensor is disabled
SCROLL
SUB-MENU (lower line only)
#### KNIFE SPEED
##.# HEADER HEIGHT
LOAD|
■■■■
|
■■■■
| ####
##.## REEL MPH
##.# DRAPER SPEED
Displays the sub-menu after two to three seconds. Press SELECT to exit the
sub-menu. Use the CDM switch to scroll through the sub-menu options
KNIFE SPD OVERLOAD
This message appears if the knife speed drops below its programmed
threshold value
Cab-Forward, Engine Running, Header Engaged, Draper Header Attached, Index Switch ON
These are the messages which can appear in the cab display module (CDM) when the windrower is in cab-forward mode,
the engine is running, the attached draper header is engaged, and the header index switch is set to the ON state.
Display (Lower or Upper Line)
Description
#####.# ENGINE HRS
Displays the total engine operating time
#####.# UNIT HRS
Displays the windrower
’
s total operating time
#####.# HEADER HRS
Displays the header
’
s total operating time
##.# ACRES/HOUR
##.# HECTARES/HOUR (if metric)
Displays the actual cutting rate in acres or hectares per hour
###.# SUB ACRES
###.# SUB HECTARES (if metric)
Displays the total area cut since the last reset was performed. To reset this
value: set the CDM to display SUB ACRES on the lower line, then hold down
the PROGRAM switch for five to seven seconds until the display resets
###### TOTAL ACRES
###### TOTAL HECT (if metric)
Displays the total area cut by the machine
##.## ##.# REEL IND
REEL.SENSOR
Displays the reel
’
s indexed speed in rpm and the windrower
’
s ground speed
in mph or km/h
This message appears if the reel sensor is disabled. The messages IND and
SENSOR appear alternately at one-second intervals
##.# ##.# DRAP INDX
Displays the indexed speed of the draper in rpm and the windrower
’
s
ground speed in mph or km/h
#### KNIFE SPEED
#### KNIFE SENSOR
Displays the knife speed in strokes per minute
This message appears if the knife speed sensor is disabled. The messages
SPEED and SENSOR appear alternately at one-second intervals
11. A sensor which can monitor the knife/conditioner circuit pressure can be installed as an optional kit. To monitor the
hydraulic pressure of the reel/auger circuit, relocate the sensor per kit instruction MD #169031; this instruction is
available from your MacDon Dealer.
