215676
151
Revision A
1009303
CXXX
MXXX
TO ACTIVATE PURGE
PRESS AND HOLD
B
A
Figure 3.215: Hydraulic Purge
7.
Press SELECT (B) until ACTIVATE HYD PURGE? appears on
the upper line.
•
NO/YES will appear on the lower line.
8.
Press right arrow (A) to select YES. Press SELECT (B).
•
TO ACTIVATE PURGE will appear on the upper line.
•
PRESS AND HOLD will appear on the lower line.
NOTE:
Holding right arrow (A) activates a timed purge cycle. The
CDM will jump to the exit menu if the arrow is released
before the end of the timed cycle.
1009305
CXXX
MXXX
PURGE CYCLE STARTED
PRESS AND HOLD
A
Figure 3.216: Hydraulic Purge Cycle
9.
Press and hold right arrow (A) to begin the purge cycle.
•
PURGE CYCLE STARTED will appear on the upper line.
10. When the message PURGE CYCLE ENDED appears, release
right arrow (A).
•
NO EXIT YES will appear on the lower line.
11. Press the right arrow to select YES. Press SELECT.
12. Press PROGRAM to exit programming mode or press
SELECT to proceed to the next header function option.
3.19.15
Engine Error Codes
To assist the Operator or Technician in diagnosing engine problems, the cab display module (CDM) displays error codes
when there is a fault with one or more of the sensors which monitor engine operation parameters.
For an explanation of an engine error code, refer to
8.4 Engine Error Codes, page 480
3.19.16
Cab Display Module and Windrower Control Module Fault Codes
To assist the Operator or Technician in locating a specific problem with the windrower, the cab display module (CDM)
displays fault codes when there is a fault with one of the sensors which monitor windrower performance parameters.
For an explanation of a fault code, refer to
8.5 Cab Display Module Error Codes, page 491
.
