215676
107
Revision A
6.
Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to the next WINDROWER SETUP
option.
Setting Engine Intermediate Speed Control
The engine
’
s Intermediate Speed Control (ISC) feature provides three selectable engine speeds (1900, 2050, or 2200 rpm)
for reduced load conditions. This setting can be configured in the windrower
’
s cab display module (CDM) by accessing the
WINDROWER SETUP menu.
NOTE:
The programmed engine speed is activated when the header is engaged. For more information, refer to
Intermediate Speed Control, page 162
The engine
MUST
be running for this procedure to be performed.
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 3.112: CDM Programming Buttons
1.
Start the engine.
2.
Press PROGRAM (A) and SELECT (C) on the cab display
module (CDM) to enter programming mode.
•
WINDROWER SETUP? will appear on the upper line.
•
NO/YES will appear on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? will appear on the upper line.
CXXX
MXXX
SET ENGINE ISC RPM?
NO/YES
1030043
B
A
Figure 3.113: Engine ISC RPM
4.
Press SELECT (B) until SET ENGINE ISC RPM? appears on the
upper line.
•
NO/YES will appear on the lower line.
5.
Press right arrow (A) to select YES. Press SELECT (B).
•
PRESS HAZARD TO SET will appear on the upper line.
•
ISC RPM #### will appear on the lower line.
Table 3.3 ISC Settings
ISC and rpm
Off
16
1
2
3
High Idle
17
2200
18
2000
1800
NOTE:
The previously selected ISC setting will flash.
16. Off is always used when the header is not engaged.
17. Off does not appear as a menu selection, but is used when the header is not engaged.
18. Default setting.
