215676
200
Revision A
1007798
A
B
Figure 4.80: Lift Linkage
9.
Start the engine, and lower the header onto the ground
until member (A) lifts off of link (B) on both sides of the
header.
10. Stop the engine, and remove the key from the ignition.
1000733
A
B
Figure 4.81: Lift Linkage
11. On the high side of the linkage, remove nut, washer, and
bolt (A) which attach shims (B) to the link.
12. Remove one or both shims (B), and reinstall hardware (A).
1000732
A
B
Figure 4.82: Lift Linkage
13. Start the engine and raise the header fully.
14. Stop the engine and remove the key from the ignition.
15. Move the float pins to the disengaged position.
16. Start the engine, and adjust the height of the header so
that it sits approximately 150 mm (6 in.) off of the ground.
17. Check that member (A) is resting against link (B).
18. Shut down the engine, and remove the key from
the ignition.
19. Measure the distance to the ground at both ends of the
header. If the values are the same, then no float adjustment
is necessary. If they are different, then the side with the
greater distance between the ground and the bottom of
the header will need to be adjusted.
