Connecting booster cables
1. To access the windrower batteries, remove the battery
cover. Refer to
Opening Battery Cover, page 306
.
2. Pull back the red rubber battery terminal cover and
connect one end of the positive (+) booster cable to
positive (+) post (A) on the dead battery.
3. Connect the other end of the positive (+) booster cable
to the positive (+) post (B) on the booster battery.
4. Connect one end of the negative (-) booster cable to
negative (-) post (C) on the booster battery.
5. Connect the other end of the negative (-) booster
cable (D) to a clean, unpainted, solid metal part on the
engine of the dead unit.
WARNING
To minimize the chance of an explosion, avoid
connecting the negative boosting cable to the
negative post on the dead battery.
6. Turn ignition switch in cab as with normal start up.
Figure 5.115: Attaching Booster Cables
Removing booster cables
IMPORTANT:
Spark hazard. When disconnecting booster cables, do
not allow the cable clamps to touch each other.
1. Disconnect the negative (-) booster cable (A) from the
engine of the unit that was boosted.
2. Disconnect the other end of the negative (-) booster
cable from the negative (-) battery post (B) of the
booster battery.
3. Disconnect the positive (+) booster cable from the
positive (+) battery post (C) of the booster battery.
4. Disconnect the other end of the positive (+) booster
cable from the positive (+) battery post (D) of the
boosted battery.
5. Replace the black and red rubber battery terminal
covers.
6. Close the battery cover.
Refer to
Figure 5.116: Removing Booster Cables
214053
309
Revision A
Summary of Contents for M1240
