6. Turn IGNITION switch (A) to the ON position, and the
Harvest Performance Tracker (HPT) (B) will illuminate.
If HPT is still booting up, wait for Wait to Start (WTS)
symbol (C) to disappear before trying to start engine.
7. Check that red PARK symbol light (D) is ON and that
there are no error messages on screen.
8. Press HORN button (E) three times.
Figure 4.13: Operator Console and HPT
Run Screen
9. Turn the IGNITION switch to crank (A).
NOTE:
When the engine starts and the header is not
engaged, the HPT will display as shown. This is
the HEADER DISENGAGED screen (B).
IMPORTANT:
• Do NOT operate starter for longer than
15 seconds at a time.
• If engine does not start, wait at least 2 minutes
before trying again.
• If you crank the engine for more than
30 seconds within a 2-minute period, the
engine will lock the starter circuit to prevent
overheating, and a
fl
ashing WTS symbol will
illuminate on the HPT display. Wait for the
WTS symbol to stop
fl
ashing before attempting
to crank engine again.
• If engine still does not start, refer to
Start Troubleshooting Tips, page 119
.
Figure 4.14: HPT Header Disengage Screen
214053
117
Revision A
Summary of Contents for M1240
