2. Position the draper header support (B) on lift
linkage (A), and reinstall clevis pin (C).
NOTE:
To avoid pin snagging the windrow, install the clevis
pin on the outboard side of the draper header
support.
3. Secure clevis pin (C) with hairpin (D).
4. Repeat for opposite lift linkage.
Figure 4.93: Draper Header Support
Attaching a D1X or D1XL Series Header
NOTE:
Draper header supports must be installed onto the windrower lift linkage before starting this procedure. Refer to
Attaching Draper Header Supports, page 155
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove
the key from the ignition before leaving the operator’s seat for any reason.
1.
For hydraulic center-link without self-alignment:
Relocate pin (A) in frame linkage as required to
raise the center-link (B) until the hook is above the
attachment pin on the header.
IMPORTANT:
If the center-link is too low, it may contact the
header as the windrower approaches the header
for hookup.
Figure 4.94: Center-Link without Self-Alignment
214053
156
Revision A
Summary of Contents for M1240
