Detaching a D1X or D1XL Series Header
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove
the key from the ignition before leaving the operator’s seat for any reason.
1. Lower the reel fully.
2. Lift the header fully.
3. Stop the engine and remove the key from the ignition.
4. Engage safety prop on the windrower’s lift cylinder
as follows:
a. Pull lever (A) and rotate toward header to release,
and lower safety prop onto cylinder.
b. Repeat for opposite lift cylinder.
IMPORTANT:
Ensure the safety props engage over the cylinder
piston rods. If safety prop does not engage
properly, raise header until prop
fi
ts over the rod.
5. Open left side platform.
Refer to
.
Figure 4.111: Engaging Cylinder Safety Prop
NOTE:
Firmly hold handle (B) when disconnecting the
multicoupler (C). Pressure may cause the handle to
kick back with force.
6. Push lock button (A) and pull handle (B) to disengage
multicoupler (C). Disconnect the hydraulics from the
rear knife/reel drive receptacle.
7. Route knife/reel drive hose bundle back to the storage
position (D) on the hydraulic hose management arm.
8. Remove any debris that may have accumulated on the
receptacle. Close the cover (E).
Figure 4.112: Knife/Reel Drive Multicoupler
214053
163
Revision A
Summary of Contents for M1240
