MacDon M1240, Operator'S Manual

Page: 82 / 488

OPERATOR’S STATION
3.16 Header Controls
All header controls are conveniently located on the operator’s console and on the ground speed lever (GSL) handle.
NOTE:
Some controls are optional equipment and may not be present in your unit. Some controls may be installed,
but are not functional for certain headers.
Refer to speci fi c header sections in this manual for detailed operating procedures for all header controls.
3.16.1 Header Engage Switch
The header engage switch (A) engages and disengages
the header drive.
To engage the header drive, pull up on the collar (B) while
depressing switch (A).
To disengage the header drive, push the switch down.
NOTE:
Although not required, it is good practice to move the
throttle lever back to IDLE before engaging header drive.
Figure 3.51: Header Engage Switch
3.16.2 Header Drive Reverse Button
NOTE:
The following header systems have reverse capability:
• D1XL Series Draper Headers: knife
• D125X Draper Headers: knife
• R85 rotary disc headers: conditioner and discs
• A40-D Auger Headers: knife, conditioner, auger and
reel
Reverse header systems as follows:
• Engage : Push and hold reverser button (B) and engage
header with switch (A).
• Disengage : Release reverser button (B).
NOTE:
To re-engage in forward operation, push switch (A) down
and then up again.
Figure 3.52: Header Drive Controls
214053
70
Revision A