3. Engage safety prop on the windrower’s lift cylinder
as follows:
a. Pull lever (A) and rotate toward header to release,
and lower safety prop onto cylinder.
b. Repeat for opposite lift cylinder.
IMPORTANT:
Ensure the safety props engage over the cylinder
piston rods. If safety prop does not engage
properly, raise header until prop
fi
ts over the rod.
4. Open left side platform.
Refer to
Figure 4.142: Engaging Cylinder Safety Prop
5. Disconnect the following electrical harness and
hydraulic hoses from the windrower:
a. Disconnect
the
disc
pressure
hose
from
receptacle (A).
b. Disconnect
the
disc
return
hose
from
receptacle (B).
c. Disconnect
the
case
drain
hose
from
receptacle (C).
d. Disconnect
the
electrical
harness
from
receptacle (D).
Figure 4.143: Header Drive Hydraulics
6. Remove hairpin (B) from clevis pin (A) and remove
clevis pin from header support (C) on both sides of
header.
Figure 4.144: Header Supports
214053
176
Revision A
Summary of Contents for M1240
