Kongsberg Simrad ST90, Reference Manual

Page: 528 / 690

526
442704/A
Description
The information imported to the ST90 system from
various sensors can also be useful for other systems
on board your vessel. The ST90 system allows
you to "re-export" this sensor information. When
activated, the selected sensor information is sent out
on the chosen communication port (serial or LAN).
The following sensor data can be exported:
• Navigation
• Motion sensor
Once an output type has been defined, it is listed in the
Installed Outputs
box on the left side
of the page. To see the relevant output parameters, select any output in the list. You can edit
the output parameters, or delete the output format to stop the export.
Note
In this context, the phrase "sensor" is used to describe an external device providing
information. This information is useful or essential for the operation of the ST90
system. Typical sensors are those providing navigational information (heading, speed or
geographical position) or vessel movements in the sea (motion sensors).
You can not define the communication port parameters here. If you need to adjust these,
you must select
I/O Setup
after you have defined the data output parameters. The
I/O Setup
page is located in the
Installation
and
Output
dialog boxes.
Details
Installed Outputs
The
Installed Outputs
box lists all the currently selected outputs. To remove or edit an
output type, select it in the
Installed Outputs
box.
• Select
Remove
to delete the output.
• Select
Edit
to change the settings.
• Select
New
to add a new output.
Output
Select which information to export. The following sensor data can be exported:
• Navigation
• Motion sensor
Simrad ST90 Reference Manual