Kongsberg Simrad ST90, Reference Manual

Page: 104 / 690

102
442704/A
6 Open the button and select
Apply to all
if you wish to use the chosen setting in all the
views in the current presentation mode.
Related topics
Operating procedures, page 79
Controlling the gain and range settings, page 94
Tilt function, page 423
Adjusting the bearing
The Horizontal view presents the 360 degrees area around your vessel from a bird’s eye
view. For the other views you must define the horizontal direction of the beam. Use
Bearing
to adjust the horizontal angle referenced to the vessel heading. You can also select the
bearing line and drag it sideways.
Context
The
Bearing
function controls the horizontal direction of the Vertical view, the audio beam
and the inspection beam. The current bearing applied to the Horizontal view is shown with a
solid line pointing out from the sonar position.
• The bearing for the Vertical view is controlled by the bearing in the Horizontal view.
• If you use a presentation mode with two horizontal views you can set
Bearing
to two
different values. Both bearing lines are shown in the Horizontal view. Both bearings are
shown as continuous lines pointing out from the sonar position. The bearing in Horizontal
1 is shown with a solid line. The bearing in Horizontal 2 is shown with a dotted line.
• If you use a presentation mode with two vertical views you can set the
Bearing
function
to two different values. Both bearing lines are shown in the Horizontal view. The bearing
for the Vertical view is shown with a solid line. The bearing for the Vertical 2 view is
shown with a dotted line.
• The solid bearing line in the Horizontal view controls the audio beam. If you have two
Horizontal views, the solid line in the Horizontal 1 view controls the audio beam.
• The area covered by the vertical beam is shown as a triangle in the Horizontal view.
Note
The choice you make is by default only applied to the currently selected (active) view. The
active view is identified with a thicker border.
A new manually initiated tracked object is automatically given priority status. The priority
is identified with a "P". The bearing and tilt settings are automatically adjusted to follow the
movements of the tracked target. The bearing line is automatically locked on the object to
reflects its bearing.
Simrad ST90 Reference Manual