Kongsberg Simrad ST90, Reference Manual

Page: 427 / 690

442704/A
425
• Select the middle of the button and keep the mouse button pressed. Drag the
cursor sideways to increase or decrease the value. Release the mouse button when
requested value is shown.
• Select the middle of the button to open it. If you have a keyboard connected to the
ST90 system, type the requested value.
Auto
This is an "on/off" function. When Auto Tilt
mode is activated the beam will automatically
change its tilt angle for each transmission
("ping").
The centre of the tilt sector is defined by the
chosen tilt angle just before the
Auto Tilt mode
is started. The chosen tilt sector is shown on
the tilt indicator in the
Horizontal view using
a shaded background.
Select
Step
to set the size (in degrees) of each tilt step.
Select
Sector
to set the size (in degrees) of the vertical tilt sector.
Tip
The Mk2 Operating Panel is fitted with three function buttons. The buttons are
identified as
F1
,
F2
and
F3
. One of these buttons can be assigned to activate the
Auto Tilt mode. The
Operating Panel
page is used to select which physical hardware
panel you use, and to assign functionality to the programmable buttons. This page
is located in the
Installation
dialog box.
Step
Select
Step
to set the size of each tilt step (in degrees) in Auto Tilt mode.
Select either side of the button to choose a value. Select the middle of the button to
open it. If you have a keyboard connected to the ST90 system, type the requested
value.
Sector
Select
Sector
to set the size (in degrees) of the vertical tilt sector in Auto Tilt mode.
Select either side of the button to choose a value. Select the middle of the button to
open it. If you have a keyboard connected to the ST90 system, type the requested
value.
Functions and dialog boxes