STATus Subsystem
15
Keysight 8990B Programming Guide
441
If the corresponding bit in:
–
STATus:DEVice:NTRansition
is 1, then bit 1 is set when a sensor is
disconnected.
–
STATus:DEVice:PTRansition
is 1, then bit 1 is set when a sensor is
connected.
The channel 1 sensor error bit (bit 3) or the channel 4 sensor error bit (bit 4), when
queried by
STATus:DEVice:CONDition?
, is set to:
– 1, when an error is detected.
– 0, when no error is detected.
The channel 1 sensor error bit (bit 3) or the channel 4 sensor error bit (bit 4), when
queried by
STATus:DEVice[:EVENt]?
, indicates whether there is an error or not
depending on the state of the corresponding bits of
STATus:DEVice:NTRansition
and
STATus:DEVice:PTRansition
. If the corresponding bit in:
–
STATus:DEVice:NTRansition
is 1, then 1 is set when no error is detected.
–
STATus:DEVice:PTRansition
is 1, then 1 is set when an error is detected.
NOTE
Querying
STATus:DEVice[:EVENt]?
clears the Device Status Event register.
Summary of Contents for 8990B
Page 1: ...Keysight 8990B Peak Power Analyzer Programming Guide ...
Page 16: ...16 Keysight 8990B Programming Guide THIS PAGE HAS BEEN INTENTIONALLY LEFT BLANK ...
Page 18: ...18 Keysight 8990B Programming Guide THIS PAGE HAS BEEN INTENTIONALLY LEFT BLANK ...
Page 20: ...20 Keysight 8990B Programming Guide THIS PAGE HAS BEEN INTENTIONALLY LEFT BLANK ...