JANOME Embroidery Software Instruction Book
Chapter 9 Outline & Fill Stitches
72
3
If not already applied, select
Candlewicking Run Line
from the
Stitch Type
list.
4
Adjust
Size
and
Spacing
as required.
5
Click
OK
to apply.
Creating sculpture run outlines
The Sculpture Run outline is use to simulate line
stitches used in quilting. It is a variation of multiple
run stitching, where each alternative
triple/multiple run stitch is replaced by a single run
stitch. Sculpture Run outline is recommended for
use only with MC11000. Recommended sewing
settings include:
Note Results will vary depending on fabric and
other sewing conditions. In this case, it is
recommended to use Hand-looking Quilting Stitch
of MC11000 Special Edition. Test your design on a
small piece of fabric before stitching your project.
To create a sculpture run outline
1
Click the
Sculpture Run
icon and digitize a sculpture
run outline as you would a run stitch outline. See
Digitizing lines
for details.
2
Double-click to access
object details
.
3
If not already applied, select
Sculpture Run Line
from
the
Stitch Type
list.
4
Adjust
Stitch Length
as required.
Use Digitize > Sculpture Run to digitize sculpture
run outlines.
Setting
Recommended
Needle
Red Tip needle #14
Needle thread
Monofilament clear thread #60 (with
spool net)
Bobbin thread
Rayon #60 (75d)
Bobbin holder
Janome Bobbin holder for hand-look
stitching (#200-445-007) (preset with
lower tension)
Upper thread
tension
7
Stitch length
2
Speed
400 spm
Summary of Contents for Digitizer MB
Page 236: ...234 Part IX Software Feature Table...
