JANOME Embroidery Software Instruction Book
Chapter 18 Object Details, Fabrics and Templates
137
Zigzag, Center Run + Zigzag, etc. This allows you
to apply dual underlays to design objects.
Note Any combination containing Center Run
cannot be used with Parallel Fill or Parallel Fill
Rectangle objects.
To change underlays
1
Select and double-click a fill object.
The
Object Details
dialog opens.
2
Select the
Underlay
tab.
3
If not already checked, select the
Underlay
checkbox.
4
Make a selection from the
Underlay Type
list.
5
Click
OK
.
Adjusting Center Run and Edge Run
underlay settings
Center Run places a row of stitches along the
center of a column. It is used to stabilize narrow
columns – e.g. 2-3mm wide. Edge Run places
stitches around the edge of an object.
Note You cannot use Center Run with Parallel
Fill or Parallel Fill Rectangle objects.
To adjust Center Run or Edge Run underlay
settings
1
Select and double-click a fill object.
The
Object Details
dialog opens.
2
Select the
Underlay
tab.
3
Select
Center Run
or
Edge Run
from the
Underlay
Type
list.
4
Adjust
Stitch Length
setting as required:
5
Click
OK
.
Adjusting Zigzag underlay settings
Use Zigzag underlay stitching to support wide
columns. You can set stitch length properties for
Zigzag underlay. The stitch length is the length of
each zigzag stitch.
To adjust Zigzag underlay settings
1
Select and double-click a fill object.
The
Object Details
dialog opens.
2
Select the
Underlay
tab.
Select
underlay
Select
underlay type
Enter required
stitch length
Stitch length:
2.0 mm
Stitch length:
4.0 mm
Summary of Contents for Digitizer MB
Page 236: ...234 Part IX Software Feature Table...
