Intermec Trakker Antares 2460, User Manual

Page: 56 / 291

TRAKKER Antares 246X Stationary Terminal User’s Manual nugget
39
3-10
Restoring the Terminal’s Default Configuration
When you configure the 246X terminal according to the instructions presented in this
chapter, the parameters remain in effect until you reconfigure them. If you configure the
terminal but do not save your changes in flash memory, the parameters will remain in
effect until you boot or reset the terminal.
The default configuration for the terminal is listed in Appendix A. You can scan the
Default Configuration bar code label to return the terminal to its default configuration.
Note: If you restore the default configuration, you may need to reset the serial port or
Ethernet parameters to communicate with other devices in your network.
To restore the default configuration using the reader command
•
Scan this bar code label:
Default Configuration
*.+0*
*.+0*
Upgrading the Firmware
The terminal firmware includes these items:
•
Sample application
•
Operating environment, firmware, and drivers
You can upgrade a terminal to use the latest firmware version without making any
hardware changes. There are two upgrade kits:
Firmware Upgrade Kit Part Number Description
TRAKKER Antares TCP/IP 066814S Order this kit for terminals that
communicate in a TCP/IP direct
connect network or a TCP/IP
pass-through network.
TRAKKER Antares UDP Plus 067119S Order this kit for terminals that
communicate with a DCS 300 in
a UDP Plus network.
For the 2461, order the kit that works with your protocol. For the 2460, order either kit.
To order a firmware upgrade kit, contact your local Intermec service representative.
Each kit comes with a utility and instructions to upgrade the firmware on the terminal.