Intermec Trakker Antares 2460, User Manual

Page: 211 / 291

Nugg
C d 39
Configuration Command Reference
8-63
8
Scan: To disable poll, scan one of these bar codes:
Disable Poll for COM1
*$+YR1.*
*$+YR1.*
Disable Poll for COM2
*$+YR2.*
*$+YR2.*
Or: To enable poll, scan one of these bar codes:
Note: To scan the following bar codes, you must configure the terminal to use Code 39
in Full ASCII mode. For help, see “Code 39” earlier in this chapter.
Enable Poll (Set to FS) for COM1
*/D/KYR1.%B*
*$+YR1.%B*
Enable Poll (Set to FS) for COM2
*/D/KYR2.%B*
*$+YR2.%B*
Note: FS is encoded as %B in a Code 39 bar code label.
Notes: For COM1 only, you can use either command syntax listed next:
Syntax: YR1.data
Or: HBdata
where data is disabled or enabled (set to FS). For COM2, you must use the YR
configuration command.