Intermec Trakker Antares 2460, User Manual

Page: 79 / 291

nugget
39
Operating the Terminal in a Network
4-21
4
The 2461 returns this transaction to the host application.
Cg$+NA1BV4
where:
Cg is a TMF Configuration Get response.
$+ is the Change Configuration reader command.
NA1 means the Network Activate configuration command is currently set to a
value of 1, which means that the Ethernet network is enabled.
BV4 means the Beep Volume configuration command is currently set to a value of
4, which is a very loud beep volume.
Example 2
In the host application, you want to set the value for two configuration commands on
the 2461. Send this transaction from the host application:
CS$+BV3KA1
Note: The transaction header is not shown in this example. You do not need a
transaction header for a host application in a TCP/IP network.
where:
CS is a TMF Configuration Set request.
$+ is the Change Configuration reader command.
BV3 sets the Beep Volume configuration command to a value of 3, which is a very
loud beep volume.
KA1 sets the Keypad Caps Lock configuration command to a value of 1, which
enables the Keypad Caps Lock.
The 2461 returns this transaction to the host application.
Cs$+BV3KA1
where:
Cs is a TMF Configuration Set response.
$+ is the Change Configuration reader command.
BV3 means the Beep Volume configuration command has been changed to a value
of 3, which is a loud beep volume.
KA1 means the Keypad Caps Lock configuration command has been changed to a
value of 1, which enables the Keypad Caps Lock.