Intermec Trakker Antares 2460, User Manual

Page: 227 / 291

Nugg
C d 39
Configuration Command Reference
8-79
8
2. Scan one of these bar codes to set the COM port:
COM1 COM2
*1.* *2.*
*1.* *2.*
3. Scan a bar code for data from the “Full ASCII Bar Code Chart” in Appendix B.
4. Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
Notes: For COM1 only, you can use either command syntax listed next:
Syntax: YY1.data
Or: PEdata
where data is any ASCII character. For COM2, you must use the YY configuration
command.
Stop Bits
Purpose: Sets the number of stop bits on the serial port.
Syntax: YCn.data
where n is:
1 COM1 port
2 COM2 port
Acceptable values for data are:
1 1 stop bit
2 2 stop bits
Default: 1
Scan: To set the number of stop bits to 1, scan one of these bar codes:
1 Stop Bit for COM1
*$+YC1.1*
*$+YC1.1*