Intermec Trakker Antares 2460, User Manual

Page: 144 / 291

TRAKKER Antares 246X Stationary Terminal User’s Manual nugget
39
7-24
Transmit File Through the Serial Port (continued)
drive: indicates the drive where the file is stored on the terminal. You must
include the colon (:) after the drive letter.
filename is the file you want to transmit.
Keypad: Not supported
Note: To scan these bar code labels, you must configure the terminal to use Code 39 in
Full ASCII mode. For help, see “Code 39” in Chapter 8.
Scan: 1. Scan this bar code label:
Enter Accumulate Mode / Transmit File
*/K/O/E/E*
*+/%%*
2. Scan the bar code label for the communications protocol you want to use.
XMODEM XMODEM-1K YMODEM
*X* *K* *Y*
*X* *K* *Y*
3. Scan the bar code label for the terminal COM port you are using to transmit the
file. The label also includes the required comma.
COM1 COM2 (2460 only)
*1/L* *2/L*
*1,* *2,*
4. Scan the bar code label(s) for the file you want to transmit. You can scan labels
from the “Full ASCII Bar Code Chart” in Appendix B. The label must use this
format:
drive:filename
5. Scan this bar code label to exit Accumulate mode and transmit the file.
Exit Accumulate Mode
*-/*
*-/*