Intermec Trakker Antares 2460, User Manual

Page: 181 / 291

Nugg
C d 39
Configuration Command Reference
8-33
8
3. Scan the number of data bits:
7 Data Bits 8 Data Bits
*7* *8*
*7* *8*
4. Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
5. Repeat Steps 1 through 4 to set the data bits for another serial port.
Notes: For COM1 only, you can use either command syntax listed next:
Syntax: YI1.data
Or: IIdata
where data is a value of 7 or 8 data bits. For COM2, you must use the YI configuration
command.
Decode Security
Purpose: Defines the security level to use when decoding bar codes. When you select a lower
decode security level, the terminal can decode bar codes with poorer print quality.
Note: Only use the low parameter as a temporary solution until you can improve the
bar code label print quality.
Syntax: CSdata
Acceptable values for data are:
0 Low
1 Moderate
2 High
Default: Moderate
Scan: One of these bar codes:
Low Decode Security
*$+CS0*
*$+CS0*