Intermec Trakker Antares 2460, User Manual

Page: 124 / 291

TRAKKER Antares 246X Stationary Terminal User’s Manual nugget
39
7-4
Backspace
This command deletes the last character from the current data record you
are accumulating.
Clear
This command deletes the entire data record you are accumulating.
Enter
This command will enter data as a record and leaves the terminal in Accumulate
mode.
Note: If you are not in Accumulate mode, the Backspace, Clear, and Enter commands
have no effect and you will hear a low beep.
When you exit Accumulate mode, the accumulated data is “entered” as a data record.
Up to 250 characters can be held in the buffer. If the data record count exceeds 250
characters, the data is truncated. If you reset the terminal (software or hardware reset),
you exit Accumulate mode, the entire buffer is cleared, and all data accumulated is lost.
To use Accumulate mode
The syntax to use the Enter Accumulate command is:
+/ data
where:
+/ is the syntax for the Enter Accumulate mode command.
data is the optional data you want to enter. Data can be a reader command that is
executed when you exit Accumulate mode.
1. Scan this bar code label to Enter Accumulate mode:
Enter Accumulate Mode
*+/*
*+/*
2. Scan the bar code label(s) for the data you want to enter. You can scan labels from
the “Full ASCII Bar Code Chart” in Appendix B.
For example, scan this label to change the terminal’s configuration and set the
preamble to the characters ABC.
Change Configuration / Set Preamble to ABC
*$+ADABC*
*$+ADABC*