Intermec Trakker Antares 2460, User Manual

Page: 127 / 291

nugget
39
Reader Command Reference
7-7
7
Operating Reader Commands
The reader commands you can use to operate or change the terminal’s configuration are
listed in this section. The operating commands are listed in alphabetical order. You will
find these reader commands detailed in this section:
•
Boot Terminal
•
Change Configuration
•
Default Configuration
•
Multiple-Read Labels
•
Reset Firmware
•
Save Configuration in Flash Memory
•
Scanner Trigger On and Off
•
Set Time and Date
•
Status Lights Control
Boot Terminal
Purpose: Boots the terminal. The terminal runs through power-on self test (POST) to test each
major subsystem. The terminal uses the configuration currently saved in flash memory
to boot and then your application appears on the screen.
Use this command when you upgrade the firmware on the terminal or if your terminal
locks up and will not respond.
From Network:
-.1
Scan: Boot Terminal
*-.1*
*-.1*