FluoroMax-3 v. 3.1 (3 Mar 2006)
Troubleshooting
7-3
Note:
You can hear these sounds only if the laboratory envi-
ronment is quiet, and your hearing is good.
Checking the FluoroMax
®
’s BIOS
1
Check by listening to the boot-up sequence.
a
About 30 s after switching on the FluoroMax
®
, the instrument beeps.
b
After this initial beep, about 1 min later the instrument emits two more
very quiet chirps.
2
Set up the BIOS on
the computer board.
a
Switch off the FluoroMax
®
.
b
On the right side of the
FluoroMax
®
, attach an SVGA
monitor to the
VIDEO
connector, and a keyboard to
the
KBD
connector.
c
Switch on the FluoroMax
®
.
A number of messages scroll down
the monitor. The last message should
be something similar to “
CMOS
checksum error
”. If so, continue
to the next step. If not, call the Spex
®
Fluorescence Service Department.
d
Press the
RESET
button on the right side of the FluoroMax
®
.
The FluoroMax
®
reboots. The following message appears at the bottom of the
monitor: “
Press DEL to enter SETUP
”.
e
Press the
DELETE
key.
The
CMOS SETUP Utility
screen appears.
f
Check the following settings; change them as necessary. Leave the other
settings as they are.
Use the
↑
and
↓
keys to move the cursor, and the
Page Down
key to change
values.
Summary of Contents for FluoroMax-3
