16-5
dummyhead
dummyhead
HYDRAULIC BRAKE (XR125LK/LEK)
If the brake bleeder is not available, perform the
following procedure.
Pump up the system pressure with the brake lever [1]
until the lever resistance is felt.
Do not release the
brake lever until the
bleed valve has
been closed.
Connect a bleed hose [1] to the bleed valve [2] and
bleed the system as follows:
1. Squeeze the brake lever all the way and loosen the
bleed valve 1/2 of a turn. Wait several seconds and
then close the bleed valve.
2. Release the brake lever slowly and wait several
seconds after it reaches the end of its travel.
3. Repeat the steps 1 and 2 until there are no air
bubbles in the bleed hose.
After bleeding the system completely, tighten the bleed
valve.
Fill the reservoir to the casting ledge [1] with DOT 3 or
DOT 4 brake fluid from a sealed container.
Install the diaphragm [1], set plate [2] and reservoir cap
[3].
Install and tighten the screws [4] to the specified torque.
[1]
TORQUE: 5.4 N·m (0.6 kgf·m, 4.0 lbf·ft)
[1]
[2]
[1]
TORQUE: 1.5 N·m (0.2 kgf·m, 1.1 lbf·ft)
[4]
[3]
[2]
[1]
Summary of Contents for XL125LK
