14-27
dummyhead
dummyhead
FRONT WHEEL/BRAKE/SUSPENSION/STEERING
Install the steering stem cap [1].
Make sure that the steering stem moves smoothly, not
loosely or tightly.
Install the meter holder and two bolts.
Install the turn signal lights [1] and top bridge pinch
bolts [2].
Connect the turn signal light connectors [1].
Install the bottom bridge pinch bolts.
Install the forks (page 14-20).
Install the following:
– Combination meter (page 18-6)
– Front visor (page 2-4)
– Handlebar (page 14-6)
– Front wheel (page 14-9)
STEERING BEARING PRELOAD
Raise the front wheel off the ground.
Position the steering stem to the straight ahead
position.
Hook a spring scale to the fork tube between the fork
top and bottom bridges.
Make sure that there is no cable or wire harness
interference.
Pull the spring scale keeping the scale at a right angle
to the steering stem.
Read the scale at the point where the steering stem just
starts to move.
If the readings do not fall within the limits, readjust the
steering top thread.
Install the removed parts in the reverse order of
removal.
[1]
[2]
[1]
[1]
STEERING BEARING PRELOAD:
11.8 – 17.7 N (1.2 – 1.8 kgf, 2.6 – 4.0 lbf)
90°
Summary of Contents for XL125LK
