Honda XL125LK, Owner'S Manual

Page: 193 / 243

15-6
dummyhead dummyhead
REAR WHEEL/BRAKE/SUSPENSION
WHEEL BEARING REPLACEMENT
Install the remover head into the bearing.
From the opposite side of the wheel, install the bearing
remover shaft and drive the bearing out of the wheel
hub.
Remove the distance collar and drive out the other
bearing.
Drive in a new right side (brake drum side) bearing
squarely with the sealed side facing up until it is fully
seated.
Coat a distance collar with grease and install it.
Pack new bearing cavities with grease.
Drive in a new left side (driven sprocket side) bearing
[1] with the sealed side facing up until it is fully seated.
INSTALLATION
Install the side collar [1].
Install the brake panel [2] into the wheel hub.
Place the rear wheel in the swingarm by aligning the
brake panel groove with the swingarm boss.
TOOLS:
[1] Bearing remover head, 17 mm
07746-0050500
[2] Bearing remover shaft 07746-0050100
[1]
[2]
TOOLS:
Driver
07749-0010000
Attachment, 37 x 40 mm 07746-0010200
Pilot, 17 mm 07746-0040400
TOOLS:
[2] Driver
07749-0010000
[3] Attachment, 42 x 47 mm 07746-0010300
[4] Pilot, 17 mm 07746-0040400
[1]
[2]
[3]
[4]
Do not get grease
on the brake drum
and shoe linings.
[1]
[2]
Align