Honda XL125LK, Owner'S Manual

Page: 232 / 243

18-11
dummyhead dummyhead
LIGHTS/METER/SWITCHES
TURN SIGNAL RELAY
INSPECTION
1. Recommended Inspection
Check the following:
– Battery condition
– Burned out bulb or non-specified wattage
– Burned fuse
– Ignition switch and turn signal switch function
– Loose connector
Check for the above items.
Are the above items in good condition?
NO – Replace or repair the malfunction part(s)
YES – GO TO STEP 2.
2. Turn Signal Circuit Inspection
Remove the front visor (page 2-4).
Disconnect the 3P (Black) connector [1] from the
turn signal relay [2].
Short the Black/brown and Gray terminals of the
turn signal relay connector with a jumper wire. Start
the engine and check the turn signal light by turning
the switch ON.
Is the light come on?
YES – • Faulty turn signal relay
• Poor connection of the connector.
NO – Broken wire harness
HORN
REMOVAL/INSTALLATION
Disconnect the connectors [1] from the horn [2].
Remove the bolt [3] and horn.
Installation is in the reverse order of removal.
INSPECTION
Disconnect the wire connectors from the horn.
Connect the 12 V battery to the horn terminals.
The horn is normal if it sounds when the battery is
connected across the horn terminals.
[1]
[2]
[1] [3]
[2]