Honda XL125LK, Owner'S Manual

Page: 195 / 243

15-8
dummyhead dummyhead
REAR WHEEL/BRAKE/SUSPENSION
ASSEMBLY
Apply grease to lips of new dust seals [1].
Install the dust seals with the flat surface facing out until
they are seated.
Install the lock washer [2], aligning its tabs with the lug
[3] on the brake panel.
Apply grease to the spindle groove in the brake cam [1].
Insert the brake cam through the lock washer [2] and
brake panel.
Install the indicator plate [3] by aligning the wide tooth
with the wide groove in the brake cam.
Install the brake arm [1] by aligning the punch marks
[2].
Install the bolt [3] from the punch mark side and tighten
the nut [4].
Install the arm cover [5] over the brake arm as shown.
Apply grease to the anchor pin [1] and brake cam [2]
sliding surfaces.
Assemble the brake shoes [3] and springs [4] as shown.
Install the shoe assembly onto the brake panel.
Wipe any excess grease from the brake cam and
anchor pin.
Install the rear wheel (page 15-6).
[1]
[2] [3]
[2]
Align
[3]
[1]
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
[1]
[2]
[3]
[4] [5]
[2]
[1]
[3]
[4]