Honda XL125LK, Owner'S Manual

Page: 73 / 243

5-8
dummyhead dummyhead
ELECTRIC STARTER
FUNCTION INSPECTION
Remove the starter relay switch (page 5-7).
Connect an ohmmeter [1] to the starter relay switch [2]
cable terminals.
Connect the fully charged 12 V battery [3] to the relay
switch connector terminals.
There should be continuity between the cable terminals
while the battery is connected, and no continuity when
the battery is disconnected.
Install the starter relay switch (page 5-7).
NEUTRAL DIODE
INSPECTION
Remove the rear cowl (page 2-3).
Remove the neutral diode [1] from the connector boot.
EXCEPT NZ TYPE:
Check for continuity between the diode terminals.
When there is continuity, a small resistance value will
register.
If there is continuity in one direction, the neutral diode is
normal.
Install the neutral diode in the reverse order of removal.
NZ TYPE:
Check for continuity between the diode terminals.
When there is continuity, a small resistance value will
register.
If there is continuity in one direction, the neutral diode is
normal.
Install the neutral diode in the reverse order of removal.
CONNECTIONS: Battery (+) terminal – Yellow/red
Battery (–) terminal – Green/red
[1]
[2]
[3]
[1]
A B
A
B
B
C A
C
A
B
EXCEPT NZ TYPE:
NZ TYPE: