11-3
dummyhead
dummyhead
ALTERNATOR/STARTER CLUTCH
LEFT CRANKCASE COVER
REMOVAL
Drain the engine oil (page 3-7).
Remove the following:
– Left side cover (page 2-2)
– Drive sprocket cover (page 2-5)
Disconnect the alternator 2P connector [1] and ignition
pulse generator (Blue/yellow) wire connector [2] from
the connector boot.
Remove the neutral switch wire [1] from the left
crankcase cover ribs [2].
The left crankcase
cover (stator) is
magnetically
attracted to the
flywheel, be careful
during removal.
Loosen the left crankcase cover bolts in a crisscross
pattern in several steps.
Remove the bolts [1] and left crankcase cover [2].
Remove the dowel pins [3] and gasket [4].
INSTALLATION
Clean any gasket material from the mating surfaces of
the left crankcase and cover.
Install the dowel pins and a new gasket.
Install the left crankcase cover and bolts, and tighten
the bolts in a crisscross pattern in several steps.
Install the following:
– Drive sprocket cover (page 2-5)
– Left side cover (page 2-2)
Fill the crankcase with the recommended engine oil
(page 3-7).
[1]/[2]
[1]
[2]
Be careful not to
damage the mating
surfaces.
[4]
[3]
[2]
[1]
Summary of Contents for XL125LK
