Honda XL125LK, Owner'S Manual

Page: 169 / 243

14-10
dummyhead dummyhead
FRONT WHEEL/BRAKE/SUSPENSION/STEERING
Install the wheel assembly onto the fork legs so that the
brake disc is positioned between the pads, being
careful not to damage the pads.
Align the groove on the speedometer gear box with the
lug on the right fork leg as shown.
Install the front axle [1] from the right side.
Install and tighten the front axle nut [1] to the specified
torque.
Install the rubber cap [2] to the axle nut.
Connect the speedometer cable [1] to the gear box and
secure it with the set screw [2].
With the front brake applied, pump the fork up and
down several times to seat the axle and check the front
brake operation.
REMOVAL (XL125LK)
Raise and support the motorcycle using safety stand or
a hoist.
Release the tab [1] while pushing it and disconnect the
speedometer cable [2].
Remove the adjusting nut [3] and joint pin [4], and
disconnect the brake cable [5] from the brake panel.
Remove the axle nut [6] and pull out the axle [7].
Remove the front wheel.
Align
[1]
TORQUE: 44 N·m (4.5 kgf·m, 32 lbf·ft)
[1]
[2]
[2]
[1]
[6]/[7]
[1]
[2]
[3] [4]
[5]