Honda XL125LK, Owner'S Manual

Page: 165 / 243

14-6
dummyhead dummyhead
FRONT WHEEL/BRAKE/SUSPENSION/STEERING
Remove the left handlebar switch housing screws [1].
Remove the left handlebar switch housing [2] from the
handlebar.
Remove the handlebar holder bolts [1] and holders [2].
Remove the handlebar [3].
INSTALLATION
Place the handlebar onto the lower holders by aligning
the punch mark on the handlebar with the mating
surface of the lower holder.
Place the upper holders with the punch marks [4] facing
forward.
Install the handlebar holder bolts and tighten the front
bolts first, then the rear bolts.
Allow the adhesive
to dry for an hour
before using.
Apply Honda Bond A [1] or an equivalent to the inside of
the grip [2] and the clean surfaces of the left handlebar
and throttle grip.
Wait 3-5 minutes to install the grip.
Rotate the grip to spread the adhesive evenly.
Install the left handlebar switch housing [1] onto the
handlebar by aligning the locating pin [2] with the hole
[3] in the handlebar.
[1]
[2]
TORQUE: 26 N·m (2.7 kgf·m, 19 lbf·ft)
[4]
[1]
Align
[1]
[2] [3]
[4]
[2]
[1]
[3]
[2]
[1]