Honda XL125LK, Owner'S Manual

Page: 56 / 243

3-15
dummyhead dummyhead
MAINTENANCE
HEADLIGHT AIM
• Adjust the headlight beam as specified by local laws
and regulations.
Place the motorcycle on a level surface.
Adjust the headlight beam vertically by turning the
adjusting screw [1].
CLUTCH SYSTEM
Inspect the clutch cable for kinks or damage, and
lubricate the cable if necessary.
Measure the clutch lever free play at the end of the
lever.
Minor adjustment are made with the upper adjuster at
the clutch lever.
Slide the dust cover [1] off, loosen the lock nut [2] and
turn the adjuster [3] to obtain the freeplay.
Tighten the lock nut and install the dust cover.
The adjuster may be damaged if it is positioned too far
out, leaving minimal thread engagement.
If the adjuster is threaded out near the limit and the
correct free play cannot be obtained, turn the adjuster
all the way in and back out one turn.
Tighten the lock nut and make major adjustments as
described below.
Major adjustments are made with the lower adjusting
nut at the engine.
Loosen the lock nut [1] and turn the adjusting nut [2].
After adjustment is complete, tighten the lock nut while
holding the adjusting nut.
Check the clutch operation.
If the free play cannot be obtained, or the clutch slips
during the test ride, disassemble and inspect the clutch
(page 10-7).
[1]
FREEPLAY: 10 – 20 mm (0.4 – 0.8 in)
10 – 20 mm
(0.4 – 0.8 in)
[1]
[2] [3]
[1] [2]