Honda XL125LK, Owner'S Manual

Page: 83 / 243

6-10
dummyhead dummyhead
FUEL SYSTEM
Install the throttle valve spring [1] onto the throttle cable
[2].
Connect the throttle cable to the throttle valve [3] while
compressing the throttle valve spring.
Be careful not to damage the jet needle when installing
the throttle valve [1] into the carburetor body.
Install the throttle valve while aligning its cut-out [2] with
the throttle stop screw [3].
Tighten the carburetor top securely.
Install the following:
– Right side cover (page 2-2)
– Right side shroud (page 2-4)
After installing the throttle valve, check the following.
– Throttle grip free play (page 3-3)
– Engine idle speed (page 3-8)
CARBURETOR HEATER (EXCEPT CO,
III LA TYPES)
CARBURETOR HEATER REMOVAL/
INSTALLATION
Remove the screw [1] and carburetor heater cover [2].
Disconnect the carburetor heater connector [1] and
ground wire connector [2].
[3]
[2]
[1]
[1]
[2]
[3]
[1]
[2]
[1]
[2]