®
23801 E. La Palma Ave., Yorba Linda, Ca 92887 Ph. 714.692.8180, Fax. 714.692.5016
www.cobrausa.com
04/17
®
1
*
Cobra
®
recommends you always wear a helmet while riding. Please never operate your motorcycle while under
the influence of alcohol and/or drugs. Enjoy the new look of your motorcycle and please ride safely.
Items Supplied >
1 - RACK
4 - 1/4-20 BUTTON HEAD SCREWS
4 -
1/4” FLAT WASHERS
8 - RUBBER WASHERS
Application(s) >
HARLEY:
TRIKE FREEWHEELER
15-19
Instruction Manual >
Read all instructions carefully and completely before installing your new Rack!
1.
Open the trunk lid and remove any loose items from the trunk. Make sure to brace the trunk lid in the open
position so that it will not move when installing the rack.
2.
Find the 4 mounting bosses on the underside of the trunk lid. These are the drill locations for the rack. See
FIGURE 1
.
3.
Th
ere should be a small indentation marking the very center of the bosses. Using a 1/16” diameter drill, very
carefully drill 4 pilot holes from the underside of the trunk lid through the center of these indentations in the
mounting bosses. Make sure to drill perpendicular to the underside of the trunk lid surface.
4.
Apply masking tape over the holes on the top surface of the trunk lid to protect it from chipping. See
FIGURE 2
.
5.
Using a 1/8” diameter drill bit, very carefully drill from the top of the trunk lid thru the pilot holes. Make sure to drill
perpendicular to the trunk lid surface.
6.
Next, using a 9/32
” diameter drill bit, very carefully drill from the top of the trunk lid thru the pilot holes. Make sure
to drill perpendicular to the trunk lid surface.
602-3000
Page 1 of 2
DOCUMENT NO. 0017
REV. A
FIGURE 1
TRUNK RACK
MTG BOSS
TRUNK RACK
MTG BOSS
